This VLocity chip from Virtue Paintball will get the most of out the motor inside your Viewloader VLocity, It features: -- Adjustable Feed Rates up to 35BPS - set the target feed rate from 15 to 35 balls per second. -- Dramatically Improved Battery Life - Batteries now last up to 3x as long! -- Preset Modes - Choose from preset hopper settings custom designed for Xball, Semi, Ramping, Millennium & Reballs or -- Custom User Definable Mode - specify the precise settings of your VLocity with thousand of possible combinations -- Breakout Setting - "one touch" Breakout Setting instantly configures your hopper & tension settings for max feed rates on the breakout. -- Adjustable Tension - 12 force settings allow you to precisely control the pressure on the ball stack for increased out of the gate speed, improved battery life, and gentliness on paint. -- Decreasing Stack Tension (DST) - save battery power & improves performance by allowing you to set the stack tension to decrease over time when your gun is not shooting.

Electronic Anti-Jam Logic - Adjustable anti-jam setting allows you control the anti-jam logic to compensate for brittle or hard shelled paint.

Instant Unjam - Just tap the button to manually clear a jam.

Smooth Drive Operation - enhanced motor programming to allow for smoother, more consistent feeding & reduced wear on the internals.

Battery Mode Setting - Optimize performance based on the use of Lithium Ion or Alkaline batteries

Low Battery Indicator - LED alerts you when your batteries are at 25% battery capacity

Sleep Mode - save batteries with 10 minute idle sleep mode

Easy Programming Menu similar to Virtue gun software

Viewloader Factory Approved - Only upgrade that will not void your warranty

Exclusive Reball Certification - Factory approved best upgrade for using Reballs

Breakout mode explained: Before the start of a game, you can prime the loader with maximum Tension and Target Feed Speed by putting it into Breakout Mode. To do this, with the loader on, hold the program button down for 1 second, or 3 seconds. The LED will now Flash Green indicating that the loader Tension Setting and Target Feed Speed are maxed out and will remain in that state for 30 seconds if you held the program button for 1 second, or Breakout Mode will last for 60 seconds if you held down the program button for 3 seconds. You can re enable the breakout mode time at any time by holding in the program button for an additional 1 or 3 seconds.